Steps:
-Fold a piece of paper in half lengthwise.
-Unfold the paper and fold the top corners down to the center crease.
-Fold the top edges to the center crease again.
-Fold the paper in half along the center crease.
-Fold down the wings on each side.
-Fold the wings down again to create the airplane's wings.
-Adjust the wings and tail for balance.
How to Make a Cup of Coffee:
Ingredients:
1 tablespoon ground coffee
1 cup hot water
Steps:
-Place the ground coffee in a coffee filter or a coffee maker.
-Pour hot water over the coffee grounds.
-Allow the coffee to steep for a few minutes.
-Stir the coffee gently.
-Place a cup under the coffee filter or coffee maker.
-Pour the coffee into the cup.
-Add sugar or milk if desired.
Steps:
-Choose a suitable location for the flower bed with adequate sunlight and well-drained soil.
-Prepare the soil by removing any weeds or debris and loosening it with a garden fork or tiller.
-Dig a hole in the soil that is slightly larger than the flower's root ball.
-Place the flower's root ball into the hole, making sure it is level with or slightly above the soil surface.
-Backfill the hole with soil, gently pressing it down to remove any air pockets.
-Water the newly planted flower thoroughly.
-Mulch around the base of the flower to retain moisture and suppress weed growth.
Ingredients:
2 1/4 cups all-purpose flour
1/2 teaspoon baking soda
1/2 teaspoon salt
1 cup unsalted butter, softened
3/4 cup granulated sugar
3/4 cup packed brown sugar
1 teaspoon vanilla extract
2 large eggs
2 cups chocolate chips
Steps:
-Preheat the oven to 350°F (175°C).
-In a bowl, combine the flour, baking soda, and salt.
-In a separate bowl, cream together the butter, granulated sugar, brown sugar, and vanilla extract.
-Beat in the eggs one at a time.
-Gradually add the flour mixture to the butter mixture, mixing well.
-Stir in the chocolate chips.
-Drop rounded tablespoons of dough onto an ungreased baking sheet.
-Bake for 9-11 minutes or until golden brown.
-Allow the cookies to cool on the baking sheet for a few minutes, then transfer them to a wire rack to cool completely.